Before Using For The First Time; Starting Up The Appliance - Melitta Solo & Perfect Milk Operating Instructions Manual

Before using for the fi rst time
Check the scope of supply
Use the following list to check the
completeness of the delivery. Please
contact your retailer if there are missing
parts.
– Cappuccinatore
– Milk hose
– Test strips to determine water hardness
General information
■ Only use pure water without
carbonation.
■ Use the supplied test strip to determine
the hardness of the water used and set
the water hardness ("Water hardness
and fi lter", page 24).
■ If you wish to use a water fi lter, do not
insert it until after the initial startup.
Information for using for
the fi rst time
The appliance must be vented before it
is used for the fi rst time. The appliance
may only be powered on with a completely
fi lled water tank.
■ Push the Cappuccinatore 13 onto the
steam pipe up to the stop 12.
■ Place a vessel under the
Cappuccinatore 13.
■ Press the
button to switch on
the appliance.
illuminates on the display.
■ Turn the valve switch 11 clockwise
until it stops. fl ashes on the display.
Water will fl ow into the vessel.
■ When
is illuminated on the display,
turn the valve switch 11 anticlockwise
until it stops.
■ The device is ready for operation.
■ After initial startup, insert the Melitta
PRO AQUA fi lter cartridge, if necessary
(see page 24).
Operating Instructions: Melitta

Starting up the appliance

Commissioning
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable!
▶ Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Image A, 14).
▶ Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
▶ Never use damaged power cables
(damaged insulation, bare wires).
■ Place the appliance on a stable, dry and
level surface with suffi cient clearance
(at least 10 cm) to the sides.
■ Push the Cappuccinatore 13 onto the
steam pipe 12 as far as it can go.
■ Plug the power cable into a suitable
power socket.
■ Remove the lid from the
bean container 8.
■ Fill the bean container with suitable
coffee beans.
■ Put the lid back on.
■ Lift up the lid of the water tank 7 and
pull the water tank up and out of the
appliance.
®
® ®
Solo & Perfect Milk | 1830-0618 | 2018-08
Before using for the fi rst time
WARNING
21