Sony Ericsson W600i Working Instruction, Mechanical page 21

16. Using a torque screwdriver set to 15 N·cm and a
Torx Plus size 5 bit, install a 1.6 X 5mm screw into
each of the four screw locations in the outer base
cover.
NOTE!
17. Using a torque screwdriver set to 15 N·cm and a
Torx Plus size 5 bit, install a 1.6 X 8mm screw into
each of the two screw locations in the inner base
cover.
NOTE!
NOTE!
18. Obtain a new screw cover panel assembly and orient
the assembly so that the side of the screw panel with
adhesive is towards the inner base cover.
19. Insert the screw cover panel assembly in the screw
cover's cavity and apply pressure to it for 3 seconds
so that a good bond forms between the parts.
All of the sections of the Base Reassembly following this section must be performed in sequential
order to reassemble the base portion of the phone.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
When installing these screws, if the torque
bit starts repeatedly slipping in a screw
before the screw is completely seated, that
screw must be replaced with a new screw
and the bit tip must be cleaned of any metal
shavings before proceeding.
When installing these screws, if the torque
bit starts repeatedly slipping in a screw
before the screw is completely seated, that
screw must be replaced with a new screw
and the bit tip must be cleaned of any metal
shavings before proceeding.
Make sure there is no adhesive residue in the
area where the screw cover panel mounts
onto the inner base cover. Carefully clean
off any residue in this area using alcohol
and a lint free wipe.
Working Instruction, Mechanical
21(128)