Menu Structure - SMA Sunny Island 5048 Installation Instructions Manual

Operation
Slave devices must wait for commands from the master devices. The following
message appears during this time.
The Sunny Island 5048 utilizes an operation concept referred to as "Single Point of
Operation". For a system with more than one device, all entries are made on the
master. There you configure the entire system, confirm events, warnings as well as errors
in the QCG (see section 8 "(First) Commissioning" (Page 57)) and update your firmware
when required (see section 11.7 "Firmware Update" (Page 81)).
Exception: When starting the device for the first time, you must set the slave in the QCG
and everything else is performed at the master.
Messages can be displayed at any time while the device is in operation and they
have priority over the Home Screen display.

10.1 Menu Structure

Configuration and changes to system parameters may only be performed
by suitably qualified personnel (electricians).
The menu structure is divided into two levels:
• User level
• Installer level
The menus allowing system parameters to be changed can only be reached after
entering the installer password (see section 10.5 "Entering the Installer Password" (Page
72)). These menu parameters can be used to monitor and control the Sunny Island
5048 in normal daily operation.
Page 66 SI5048-11:EE4206
Ready
Wait for Master
SMA
Technologie AG
Technical Description