Changing Transaxle Fluid; Every 1 Year; Checking Fuel Line - Kubota T2090BR-AU Operator's Manual

PERIODIC SERVICE
10. Fill with 20W50 motor oil until oil just appears at the
bottom of the oil level check port. Install the oil level
check port plug (9) into transaxle. Torque the plug
(9) to 20.34 N⋅m (15.0 lbf⋅ft).
11. Install the metal fitting assembly (5) to the transaxle
(1) and torque the metal fitting assembly (5) to
20.34 N⋅m (15.0 lbf⋅ft). Then install the barbed cap
(6) and the hose (7).
12. Proceed to the purge procedure.

2. Changing transaxle fluid

(See Replacing transaxle filter (T2290KWT) on page
59.)

EVERY 1 YEAR

1. Checking fuel line

WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
when attempting to make the following checks
and changes.
• Never fail to check the fuel lines periodically.
The fuel lines are subject to wear and aging.
Fuel may leak out onto the running engine,
causing a fire.
The fuel line is made of rubber and ages regardless of
service period.
1. If the fuel line and clamps are found damaged or
deteriorated, replace them.
IMPORTANT :
• When the fuel line is disconnected for
maintenance or repair, close both ends of
the fuel line with a piece of clean cloth or
paper to prevent dust and dirt from entering.
In addition, particular care must be taken not
to admit dust and dirt into the fuel pump.
Entrance of
malfunction of the fuel pump.
60
dust and dirt causes
(1) Fuel valve
(2) Fuel tank
(3) Fuel line
(4) Pipe clamps
T2090BR
(1) Fuel hose
(2) Fuel hose clamp
(3) Fuel filter
T2090BR-AU,T2290KW-AU,T2290KWT-AU
EVERY 600 HOURS
(A) "OPEN"
(B) "CLOSE"