Advertisement
fig.5
9.
FILTER CLEANING
9.1.
Handle the filter carefully when cleaning or installing. Unlock and carefully remove the cartridge filter and inspect it for damage. A filter
that has small holes or tears in it will not perform efficiently and should be replaced.
9.2.
To clean a dry filter, tap it inside a waste bin. (The cartridge filter is designed for dry vacuuming only). Should the filter be inadvertently
wetted it should be rinsed from the inside and allowed to air dry for 24 hours.
9.3.
DO NOT use the filter wet as the filter will clog quickly and be very difficult to clean.
9.4.
Fit a new/cleaned filter over the filter basket
9.5.
Lock in place as described in 7.1.2. (0mm clearance).
fig.7
10. MAINTENANCE
10.1.
Ensure the machine is unplugged from the power supply.
10.2.
Disconnect the hose from the drum container.
10.3.
Undo the clasps and remove motor housing from the drum container.
10.4.
Clear out any dirt or debris from the drum container and hoses.
10.5.
Frequently clean the seat where the safety float slides and inspect it periodically to check its integrity.
10.6.
Clean the foam filter by washing it in a mild soapy solution.
10.7.
Check the power cable to make sure that it is not damaged.
11. CONSUMAbLES
Locking Cartridge Filter (Must be used for dry vacuuming):
Foam Filter:
IMPORTANT! IF THE MACHINE IS USED WITHOUT A FILTER FITTED THIS MAY CAUSE
DAMAGE TO THE MOTOR AND YOUR GUARANTEE WILL bE INVALIDATED.
ALWAYS KEEP A SPARE CARTRIDGE FILTER HANDY.
Category M Dust Bags:
12. TROUbLESHOOTING
Symptom
Vacuum will not operate
Dust expelled from the motor cover
Reduced efficiency and increased motor/
speed vibration/orange light (C)
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
noTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Model no: DFS35CF
Model no: DFS35FF
Model no. DFS35PB
Possible causes
no power supply
Faulty power cable
Container full
Cartridge filter missing or damaged
There is a blockage in the nozzle/hose/
drum inlet/ filter.
Environmental Protection
WEEE Regulations
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
fig.6
Parts support is available for this product.
To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk,
email sales@sealey.co.uk or telephone
01284 757500.
Solutions
Check power supply - cable, breakers, fuses.
Unplug and check the power cable. If
damaged have it replaced by your local Sealey
dealer.
Empty container
Fit cartridge filter or replace damaged filter
See 7.1.4.. Check nozzle, hose and container inlets
and clear any blockages found. Remove filter and
clean it or install new filter.
01284 757500
01284 703534
PC35110V | Issue 3(I) 07/10/16
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
