Table of Contents
Advertisement
Available languages
Available languages
Plug
Supply
Valve
Elbow
1/2" Piping
or Tubing
Water
Supply
1. Install the Valve Body
NOTE: Apply a thread sealant where applicable.
NOTE: Do not remove thread protectors at this time.
Thread the plug button into the top of the supply valve.
Install both the supply valve and the check valve according to the
roughing-in diagram. Install two supply valves and two check
valves for a two handle bedpan washer.
Thread one supply nipple into the supply elbow outlet in the
wall. Repeat for a two handle bedpan washer.
Apply a bead of plumbers putty or other sealant to backside of
the flange according to the putty manufacturer's instructions.
Slide one flange onto and over the supply nipple until it is snug
against the finished wall. Secure with the flange setscrew. Repeat
for a two handle bedpan washer.
Remove any excess putty or sealant.
1034409-2-A
Elbow
Supply
Thread
Outlet
Supply
Protectors
Nipple
Screw
Check
Valve
4
Apply Plumbers
Putty.
Flange
Kohler Co.
Advertisement
Table of Contents
