Page 2
Double check the power cord polarity. If you plug the module backwards you might damage its electronic circuits. If you flip over your ONA, you will find the “RED” mark at the PCB power connector, which must match the colored line on the ribbon cable.
Page 3
The frequency of a VCO can be adjusted via input voltage or current modulation. ONA is an Analog oscillator, which means that no computer source code specifies or emulates the transient response behavior of its analog circuits.
Page 6
(EXP) way. (Fig. 4) • Mode Switch This switch allows you to select Fig.4 Detail of FM Selector Switch between ONA’s VCO and LFO Mode. (Fig. 5) /VCO Mode. It covers the needs of an Audio Oscillator, with frequencies between 20 Hz up to more than 40 kHz.
Page 11
ONA is factory calibrated with precision sources. The following procedure is for adjusting inaccuracies or tuning problems in your system: Turn on your modular with ONA connected and let it heat for 5 to 10 minutes. Put the Octave Knob in 0 position, and Fine Knob at 12 o’clock.
• This guarantee covers Any defect in the manufacturing of this product. Replacement or repair, as decided by NANO Modules. • This guarantee does not cover Any damage or malfunction caused by incorrect use , such as, but not limited to: Power cables connected backwards.