Table of Contents
Advertisement
SETTINGS
PROGRAMME SELECTION MODE
In the programme selection mode it is possible to
set a washing programme and to enter the user
mode to change the appliance settings.
To enter the programme selection mode, press on/
off.
The appliance is in programme selection mode
when
programme indicator is on and the
display shows the programme duration.
If the control panel does not indicate that the
appliance is in programme selection mode,
implement the CANCEL procedure.
CANCEL FUNCTION
Use CANCEL to:
•
CANCEL the currently running programme.
•
Stop the countdown of the Delay option.
•
Bring the appliance back to the programme
selection mode.
To CANCEL, press and hold
until the appliance is in programme selection mode.
USER MODE
User mode allows to change the following settings:
•
Adjust the level of the water softener according
to the water hardness.
•
Activate or deactivate the rinse aid empty
notification.
•
Activate or deactivate AirDry.
Before entering user mode, make sure the
appliance is in programme selection mode:
1. Press and hold
•
The indicators
flash.
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
Water hardness
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
and
and
.
,
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
ADJUSTING THE WATER SOFTENER
Make sure that the appliance is in user mode:
1. Press
•
The indicators
•
The indicator
•
The display shows the current setting: e.g.
2. Press
pressing increases the level number by one.
After reaching level 10, the countdown starts
again from level 1.
3. Press on/off to confirm the setting.
If you use multi-tabs containing salt
and the hardness of your water is
lower than 21°dH, you can set the
lowest water softener level. It
deactivates the salt refill indicator.
If you use standard detergent or multi-
tabs without salt, set the proper water
hardness level to keep the salt refill
indicator active.
THE WATER HARDNESS TABLE
The water softener removes minerals from the water
supply, which would have a negative effect on the
washing results and on the appliance.
The higher the content of these minerals, the harder
your water is. Water hardness is measured in
equivalent scales.
The water softener should be adjusted according to
the hardness of the water in your area. Your local
water authority can advise you on the hardness of
and
the water in your area. It is important to set the right
level of the water softener to assure good washing
results.
Clarke de-
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
.
still flashes.
= level 5.
to change the setting. Each
Water softener level
grees
58 - 63
53 - 57
46 - 52
36 - 45
and
are off.
10
9
8
7
7
Advertisement
Table of Contents
