Setting Up Your Phone
The nano‐SIM card(s) can be installed or removed while
the phone is turned on.
WARNING!
To avoid damage to the phone, do not use any other kind
of SIM cards, or any non‐standard nano‐SIM card cut
from a SIM card. Y ou can get a standard nano‐SIM card
from your service provider.
1.
Insert the tip of the tray eject tool into the hole on
the card tray.
NOTE:
Please use the tray eject tool included in the box.
Otherwise the card tray may not be ejected.
CAUTION:
Never replace the included tray eject tool with sharp
objects. Ensure that the tray eject tool is perpendicular to
the hole. Otherwise, the phone may be damaged.
5
1.
Connect the adapter to the charging jack.
2.
Connect the charger to a standard AC power outlet.
3.
Disconnect the charger when the battery is fully
charged.
NOTE:
If the battery is extremely low, you may be unable to
power on the phone even when it is being charged. In this
case, try again after charging the phone for at least 20
minutes. Contact the customer service if you still cannot
power on the phone after prolonged charging.
Powering On/Off Your Phone
Make sure the battery is charged before powering on.
Press and hold the Power key to turn on your phone.
To power off, press and hold the Power key to open
the options menu, and touch
7
>
.
2.
Pull out the card tray. You can place a nano‐SIM card
on the right card slot, and place a nano‐SIM card or a
microSDXC card(optional) on the left card slot, as
shown. Carefully slide the tray back into place.
NOTE:
The two card slots support 4G/3G/2G networks.
Charging the Phone
Your phone's battery should have enough power for the
phone to turn on, find a signal, and make a few calls. Y ou
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE‐approved chargers and USB Type‐C cables.
The use of unapproved accessories could damage your
phone or cause the battery to explode.
WARNING!
Do not remove the back cover. The battery is not
removable. Removal may cause fire or explosion.
6
NOTE:
If the screen freezes or takes too long to respond, try
pressing and holding the Power keyfor over 10 seconds
to restart the phone.
Waking Up Your Phone
Your phone automatically goes into sleep mode when it
is not in use for some time. The display is turned off to
save power and the keys are locked to prevent accidental
operations.
You can wake up your phone by turning on the display
and unlocking the keys.
1.
Press the Power keyto turn the screen on.
2.
Swipe up on the screen.
NOTE:
If you have set a face verification, a fingerprint, an unlock
pattern, a PIN or a password for your phone, you'll need
to use your face or fingerprint, draw the pattern, or enter
the PIN/password to unlock your screen.
8