Asus M8 User Manual page 82

Suspend Mode: [Save to RAM]
This field determines the type of suspend mode when the Notebook PC enters power saving. The
configuration options are: [Save To RAM] [Save To Disk]
Standby Timeout: [Off]
This option is only enabled when Customized is selected in the Power Savings field. This field
allows you to specify the period of inactivity before the system automatically switches to Standby
mode. In Standby mode, various devices including the LCD backlight are powered off and the
system enters a low power CPU state. The configuration options are: [Off] [1 Minutes] [2 Minutes]
[4 Minutes] [6 Minutes] [8 Minutes] [12 Minutes] [16 Minutes]
If Advanced Power Management (APM) is installed, this function will be controlled by APM and
may function differently depending on the APM settings.
Auto Suspend Timeout: [Off]
This field determines how much system idle time must pass before the system enters Suspend
mode. When this field is set to Off, the system cannot enter Suspend mode, which is the lowest
power state for the Notebook PC. The configuration options are: [Off] [5 Minutes] [10 Minutes] [15
Minutes] [20 Minutes] [30 Minutes] [40 Minutes] [60 Minutes]
Hard Disk Timeout: [Disabled]
This field allows you to specify the period of inactivity required before the hard disk spins down
and enters power saving mode. The configuration options are: [Disabled] [1 Minute] [2 Minutes] [4
Minutes] [6 Minutes] [8 Minutes] [10 Minutes] [15 Minutes]
Video Timeout: [Disabled]
This field allows you to specify the period of inactivity required before the display panel turns off.
The configuration options are: [Disabled] [1 Minute] [2 Minutes] [4 Minutes] [6 Minutes] [8 Min-
utes] [10 Minutes] [15 Minutes]
Resume On Modem Ring: [On]
When this field is set to On, a modem ring will cause the system to resume from Suspend mode.
NOTE: The Notebook PC does not have an internal modem, it must be purchased separately. The
configuration options are: [Off] [On]
Beep On Battery Low: [Enabled]
This option allows you to enable or disable the low battery warning beep. The configuration options
are: [Disabled] [Enabled]
82