Printed Wiring Boards And Schematic Diagrams Information - Sony KDL-32EX421 Service Manual

Switch Unit
1-2. PRINTED WIRING BOARDS AND
SCHEMATIC DIAGRAMS INFORMATION
All capacitors are in µF unless otherwise noted. pF : µµF 50WV or
less are not indicated except for electrolytics and tantalums.
All electrolytics are in 50V unless otherwise specified.
All resistors are in ohms. kΩ=1000Ω, MΩ=1000kΩ
Indication of resistance, which does not have one for rating
electrical power, is as follows:
W
/ W in resistance, / W and
1 1
4 10
: nonflammable resistor
: fusible resistor
: internal component
: panel designation and adjustment for repair
: earth ground
: earth-chassis
All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
Readings are taken with a color-bar signal input.
Readings are taken with a 10MΩ digital multimeter.
Voltages are DC with respect to ground unless otherwise noted.
Voltage variations may be noted due to normal production
tolerances.
All voltages are in V.
S : Measurement impossibility.
: B+line.
: B-line. (Actual measured value may be different).
: signal path. (RF)
Circled numbers are waveform references.
KDL-32EX421/32EX423/32EX520/32EX521/32EX523/40EX520/40EX521/40EX523/46EX520/46EX521/46EX523
KDL-32EX421/32EX423/32EX520/32EX521/32EX523/40EX520/40EX521/40EX523/46EX520/46EX521/46EX523
Figure 3-2. Board Layout for KDL-40EX520/40EX521/40EX523
GE3 Board
Figure 3-3. Board Layout for KDL-46EX520/46EX521/46EX523
Figure 1-3. KDL-46EX520/46EX521/46EX523
Pitch : 5mm
Rating electrical power :
/ W in chip resistance.
1
16
HLR2 Board
WiFi Module
(Only for EX523)
T-CON
HLR2 Board
The components identified by shading and
only with part number specified.
The symbol indicates a fast operating fuse and is displayed on the component
side of the board. Replace only with fuse of the same rating as marked.
Les composants identifies per un trame et une marque
/
1
4
securite. Ne les remplacer que par une piece portant le numero specifie.
Le symbole indique une fusible a action rapide. Doit etre remplace par une
fusible de meme yaleur, comme maque.
NOTE: The components identified by a red outline and a mark contain confidential
information. Specific instructions must be adhered to whenever these components
are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
HMS3 Board
BATV Board
HMS3 Board
symbol are critical for safety. Replace
!
! sont critiques pour la
8