Technics SC-HDA710 Operating Instructions Manual page 42

aSpeaker mode
(FRONT L)
bDelay time
(CENTER)
Speaker Setting
L
fExit
Exit
gTest
Test
signal
LS
Press RETURN to exit
jSpeaker mode
(SURROUND L)
kChannel balance
(SURROUND L)
lDelay time (SURROUND)
42
RQT5479
SLEEP DISP CANCEL
1 2 3
≥10/-/--
4 5 6
7 8 9 0
SUBTITLE TIME SEARCH
TOP MENU GROUP
ENTER
MENU RETURN
ANGLE SET UP
MARKER AUDIO OSD AUTO/MONO
DVD/CD TAPE EXT/MD TUNER
PLAY MODE
MD
A-B REPEAT
SKIP
REPEAT
MULTI – PAGE +
SHIFT
MUTING SLOW/SEARCH
BALANCE L VOLUME BALANCE R
eSpeaker mode
cSpeaker mode (FRONT R)
(CENTER)
dChannel balance
(CENTER)
0 0
C
hSpeaker
R
ms dB
0
SW
dB
iChannel
0 0 0
RS
dB ms dB
nSpeaker mode
(SURROUND R)
mChannel balance
(SURROUND R)
Initial settngs
Speaker setting
You must change these settings if you have connected another
amplifier and speakers in order to enjoy 5.1-channel surround
sound.
Speaker mode
Set the presence and size of the speakers you have connected.
The sound for a speaker channel will not be output if you set the
presence incorrectly.
You will not get the most from your speakers if you set the size
incorrectly.
1 Press the cursor buttons (
the speaker and press [ENTER].
2 Press the cursor buttons(
the setting.
Example: Left surround speaker (LS)
Yes (large)
LS
Select large if the speaker is capable of reproducing sounds
below 100 Hz. Select small for any other type of speaker.
3 Press [ENTER].
Channel balance
You can adjust the volume balance for each speaker channel.
1 Press the cursor buttons (
"Test" and press [ENTER].
A test signal is output from one speaker at a time, starting
with the front left speaker and proceeding clockwise.
2 While the speaker you want to adjust is
outputting the signal, press the cursor
buttons (
Adjust the level of the surround and center speakers so they
are the same apparent volume as the front speakers.
The front speakers cannot be adjusted here.
A test signal is not output from the subwoofer. To adjust its
volume, play something, then return to this screen to adjust
to your taste.
3 When you have finished adjustments, press
mode
[ENTER] to stop the test signal.
(SUB-
WOOFER)
balance
(SUB-
WOOFER)
) to select
or ) to change
Yes (small) No
LS
) to select
or ) to adjust the level.