Page 1
Installation Guide ® Planar Profile Mounting System for ® Planar UltraRes X Series Displays PRX75P For Models: URX75 URX75-ERO URX75-ERO-T URX85 URX85-ERO URX85-ERO-T URX100 URX100-ERO URX100-ERO-T Planar Profile Mounting System Installation Guide Page | 1 008-0217-00A...
Page 2
When you purchase a Planar product, you get more than a display; you get the service and support you need to maximize your investment. To find the latest warranty and service information regarding your Planar product, please visit http://www.planar.com/support...
Page 3
Table of Contents Unpacking and Checking Package Contents ............. 4 Installing the Planar Profile Mounting System ............5 Planar Profile Mounting System Installation Guide Page | 3 008-0217-00A...
Brackets the panel in place when installed. Planar For use when installing UltraRes X Planar UltraRes X Profile Profile Mounts. Mount Install Template Planar Profile Mount Installation Guide Planar Profile Mounting System Installation Guide Page | 4 008-0217-00A...
Page 5
Installing the Planar Profile Mounting System For Planar Profile kits, a template has been supplied in the kit to simplify installation of the Planar Profile components. If the template has been misplaced or lost, refer to the product outline drawing for pertinent dimensions on the location of the Planar Profile mount component locations.
Page 6
Using the dimensions on the template for the model being installed, mark the location of the upper-left mount position. Install the left mount as indicated. The marked position is the location of the center hole on the mount. Planar Profile Mounting System Installation Guide Page | 6 008-0217-00A...
Page 7
1 are correct. A slight variation in this location is okay due to being able to slightly move the display horizontally once installed. Planar Profile Mounting System Installation Guide Page | 7 008-0217-00A...
Page 8
Level and install the main support screws. At minimum, two pieces of mounting hardware must be used on a single hanging mount component. Place template vertically on either hook of the installed hanging mounts. Planar Profile Mounting System Installation Guide Page | 8 008-0217-00A...
Page 9
Note: The “V” notch in the template labeled for the model being installed can be used to verify the center marks made in step 1 are correct. Remove the template and repeat steps 8-9 for the other hanging mount. Planar Profile Mounting System Installation Guide Page | 9 008-0217-00A...
Page 10
Note: Two of the side mount attachment locations are slotted, in case when the panel is installed there needs to be a slight vertical adjustment in location. Release the locking tabs on the service mounts so they do not interfere with the display installation. Planar Profile Mounting System Installation Guide Page | 10 008-0217-00A...
Page 11
Planar provides lifting eyes (sold separately) for use with capable equipment (see “Using the Lifting Eyes” in the Planar UltraRes X Series User Manual). If mechanical equipment is unavailable or impractical, Planar supplies lifting straps for use with lifting displays.
Page 12
Rotate the kickstand down after pulling the panel out. The kickstands will nest into the lower panel mount brackets. Caution: Use both kickstands. Using only one will cause stresses in the panel that can cause damage. Planar Profile Mounting System Installation Guide Page | 12 008-0217-00A...