Seacock; Seawater Strainer - Kohler 14EKOZD Installation Manual

1
or or
4
Note: Position the intakes in relation to the vessel's
travel so neither is in the wake of the other.
1. Generator set intake
2. Intake
3. Aft (rearward)
4. Fore (forward)
Figure 3-3 Intake Strainer
Do not use a speed scoop or cup design intake
through-hull strainer because it can cause a ramming
effect and force water upward, past the seawater pump,
and into the engine cylinders when the vessel is moving
and the generator set is shut down.
Do not use hulls incorporating sea chests or other
designs that provide a positive pressure to the raw water
pump for the intake through-hull strainers. Positive
pressure forces water past the raw water pump and into
the engine. A sea chest is a concave molded-in-the-hull
chamber that aligns to the vessel's direction of travel. A
sea chest configuration applies positive pressure similar
to a scoop-type through-hull strainer.
14 Section 3 Cooling System
2
3
5982--3.2
3.2.2

Seacock

Mount the seacock to the hull, assemble it to the intake,
and ensure that it is accessible for operation. Figure 3-2
shows a typical installation.
Avoid overcaulking the seacock. Excess caulk reduces
water flow and, in some cases, develops a barrier that
can force water upward, past the seawater pump, and
into the engine cylinders when the vessel is moving and
the generator set is shut down.
3.2.3

Seawater Strainer

Mount the seawater strainer to the seacock or
permanent structure at a point not higher than the
seawater pump. Ensure that the strainer is accessible
for service. See Figure 3-4 for a typical installation.
Some seawater strainers include a seacock and an
intake through-hull strainer.
Maximum seawater inlet pressure at the seawater pump
is 34.5 kPa (5 psi) at rest, as well as underway at all
speeds. Excessive pressure will cause water ingestion.
1. Seawater pump
2. Seawater strainer
3. Seacock
Figure 3-4 Seawater Strainer
3 2 1
5982--3.3
TP-7045 3/18c