Brookstone Wireless Optical Mouse Quick Start Manual

Wireless Optical Mouse
COMPACT • ERGONOMIC • PORTABLE
BATTERY PRECAUTIONS
• Dispose of used batteries properly. Do not dispose of
used batteries in a fire.
• Do not leave the batteries where a child or pet could
play with or swallow them. If the batteries are swal-
lowed, contact a physician immediately.
• The batteries may explode if mistreated. Do not
attempt to recharge or disassemble the batteries.
• Use only fresh batteries of the required size and type.
Do not mix old and new batteries, different types
of batteries, or rechargeable batteries of different
capacities.
FCC INFORMATION
Caution: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply
with the limits for a Class B Digital Device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV tech-
nician for help.
LOCATION OF PARTS AND CONTROLS
USB Dongle (stored in
the battery compartment)
Battery Cover and
battery compartment
Mouse Buttons (3)
Scroll Wheel
Optical Sensor
(under mouse)
On/Off Switch
(under mouse)
INSTALLING THE BATTERIES
Your Wireless Optical Mouse requires 2 AAA batteries
(not included).
To install the batteries:
1. Slide the battery cover (identified with the
Brookstone logo) off the mouse, exposing the
battery compartment.
2. Remove the USB dongle, or leave it in its storage
slot for future use.
3. Insert two AAA batteries, following the polarity
indicators.
4. Using the alignment slots, slide the battery cover
back onto the mouse.
OPERATION
To use the Wireless Optical Mouse:
1. Slide the battery cover off the mouse and remove
the USB dongle from its storage slot. Replace the
battery cover.
2. Insert the USB dongle into a USB port on an active
device.
3. Slide the On/Off switch to the On position. The
mouse will pair with your device.
4. Use the mouse buttons and scroll wheel as
appropriate for your device.
5. To turn off the mouse, slide the On/Off switch to the
Off position.
Note: Due to the tight fit of the items in the battery
compartment, when returning the USB dongle to
its storage slot it may be necessary to remove the
batteries, insert the dongle, and reinsert the batteries.