Advertisement
*The input range for graph ranges is
9 ' 9 9 9 9 9 9 9 9 9
+ 9 7 .
e
*lf you enter a value that is outside the allowable range or if you try to perform
some other illegal operation, an error message appears on the display. When this
happens, press
error (Replay function) and make the necessary corrections,
inputting 0 for Xscl or Yscl does not set any scale.
inputting a maximum value that is less than the minimum value will reverse the
respective axis.
*lf the maximum and minimum values of an axis are equal, an error (Ma ERROR)
will be generated when an attempt is made to produce a graph.
*When a range setting is used that does not allow display of the axes, the scale
for the y-axis is indicated on either the left or right edge of the display, while that
for the x-axis is indicated on either the top or bottom edge. (In both cases, the
location of the scale is the edge which is closest to the origin (0, 0)).
*When range values are changed (reset), the graph display is cleared and the newly
set axes only are displayed.
*Range settings may cause irregular scale spacing.
*lf the range is set too wide, the graph produced may not fit on the display.
* Points of deflection sometimes exceed the capabilities of the display with graphs
that change drastically as they approach the point of deflection.
*An Ma ERROR is generated when ranges are extremely narrow.
or
to display the place in the calculation that caused the
-
9 . 9 9 9 9 9 9 9 9 9
e
through
+ 9 7
Advertisement
