Maintenance; Troubleshooting - CAME RIOLX8WS Manual

reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are fl ashing red simultane-
ously, otherwise do a reset (see THE RESETTING PROCEDURE).
Saving T1
Press, for one second, the T1 button on the RIOLX8WS card: the
CH1 and CH2 LEDs will fl ash red in alternation. Press, for one sec-
ond, the PROG button on the RIOCN8WS card or the RIOCT8WS
card: the WIRELESS LEDs, on the RIOCN8WS or the RIOCT8WS
card, will switch from fl ashing to off , and the CH1 LED on the
RIOLX8WS card will fl ash blue once and then switch off .
Saving T2
Press, for one second, the T2 button on the RIOLX8WS card: the
CH1 and CH2 LEDs will fl ash red in alternation. Press, for one sec-
ond, the PROG button on the RIOCN8WS card or the RIOCT8WS
card: the WIRELESS LEDs, on the RIOCN8WS or the RIOCT8WS
card, will switch from fl ashing to off , and the CH1 LED on the
RIOLX8WS card will fl ash blue once and then switch off .
⚠ To interrupt the SAVING procedure, PRESS the RESET button.
Resetting procedure
☞ If you replace any device on the system, you will have to RESET
and then again SAVE all of the system devices.
- Keep pressed the T2 button on for about 10 seconds on the
RIOLX8WS card, until the CH1 and CH2 LEDs fl ash red.
Batteries
⚠ Only replace with the same or equivalent battery type.
⚠ The batteries must be replaced by a specialized assistance
center and only by qualifi ed technicians.
⚠ Keep the batteries away from children's reach. If swallowed,
seek immediate medical attention.
FA00949M4A - 11/2017 FA00949M4A - 11/2017
⚠ The supplied battery's life also depends on its storage time.
Fit the batteries when memorizing.
⚠ When the batteries are almost fl at on the RIOLX8WS device,
it makes a buzzing sound every 10 seconds.

Maintenance

Clean the fl ashing light with a moist cloth; do
not use any solvents.

Troubleshooting

See the chapter on: troubleshooting issues on the RIOCT8WS or
the RIOCN8WS control card.
CAME S.p.A. declares that the RIOLX8WS fl ashing light con-
forms to the provisions of directive 2014/53/EU. The complete
wording of the EU declaration of conformity is available at the
following Internet address:www.came.com
Decommissioning and disposal. Dispose of the packaging and
the device at the end of its life cycle responsibly, in compliance
with the laws in force in the country where the product is used. The
recyclable components are marked with a symbol and the mate-
rial's ID marker.
The data and information shown in this manual are to be consid-
ered as subject to change at any time and without the need for any
advance warning. The measurements, unless otherwise stated, are
in millimeters.