Advertisement
Figure 3.
Altitude fine
Altitude
adjustment
tightening
connector
knobs (x2)
Figure 4.
4.
Place the accessory tray on TOP of the center bracket
between the tripod legs and secure it with the three
wingnut locking knobs from UNDERNEATH. (Figure 3)
4
Finder scope
thumbscrews
Figure 5.
Figure 6.
Telescope Assembly
1.
Remove the Altitude Tightening Knobs on the side of the
tube. (Figure 4)
2.
Slide the telescope tube into the slots on the ends of the
fork arms of the Yoke Mount, use the Altitude Tightening
Knobs to secure the tube to the Yoke Mount. (Figure 5)
3.
Insert the Micro-Adjustable Altitude Control into the
Altitude Knob Control Assembly on the side of the yoke
mount; the end with the fine adjustment knob goes
towards the back (the way the yoke curves). (Figure 6)
Remove the Machine Screw installed on the side of the
telescope and use this to attach the Micro-Adjustable
Altitude Control to the side of the telescope tube.
(Figure 7)
Finder Scope Assembly
1.
Remove the thumbscrews on the top of the Telescope.
Advertisement
