Table of Contents
Advertisement
Displayed messages
Troubleshooting
After having remedied the error cause, e.g. in
case of an operating error, the message will
automatically be deleted.
Updating the chart carrier
1. Open the drawer and remove both charts.
2. Close the drawer again.
The tachograph 1324 will automati-
cally update the time of the chart car-
rier, and the error symbol and the time
will then stop to flash.
Code
Meaning / measure
= Error at "B7" v-pulse output
= Internal error
= Trip without driver 1 chart
(Error code cannot be found in the error memory.)
Insert driver 1 chart.
= Power loss
(Error code cannot be found in the error memory.
The tachograph 1324 will record a power loss on the
chart,
see page 20.)
=
Error during sensor 2170 communication
=
Error in sensor 2170 key / serial number / signal
(The tachograph 1324 will record these errors on the
chart,
see page 20.)
3. Open the drawer and insert new charts if
Messages
In case one of the messages is shown
repeatedly, consult a authorized ser-
vice workshop!
necessary. The tachograph 1324 will be
ready for use again.
15
Advertisement
Table of Contents
