Advertisement
Introduction
Thank you for purchasing this Bankers Table Lamp.
Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product.
This fitting should be fitted in accordance with IEE Regulations and the Building
Warnings
Regulations. If in any doubt, or where required by law, consult a competent
person who is registered with an electrical self-certification scheme. Further
information is available online or from your Local Authority.
Always use the correct type and wattage bulb. Never exceed the wattage stated.
The flexible cable on this luminaire, if damaged, shall only be replaced by the
manufacturer or his service agent or a similar qualified person.
It is the installer's responsibility to ensure that the fixings and plugs used are suitable
for the surface you are fixing your product on.
Caution! The bulb and surrounding parts can become hot during use.
Do not cover. Keep away from curtains, bedding etc.
Always route mains cable so it does not present a hazard (entrapment, tripping etc.);
Ensure that there are no twists or snags in the cable.
Plug into the mains supply; switch on using the inline cord switch provided.
If moving this lamp, always carry by holding the stand part (and not the glass.)
Description
Parts list
A
01
Image
Quantity
Product assembly
1
2
Step 1
Carefully unpack the carton, making sure all parts
are present before assembly. Place lamp on a flat
surface
Step 2
This is fully assembled product.
Attach the correct type and wattage bulb to the
lamp holder (bulb not included).
The maximum power indicated must not be
exceeded.
Step 3
Insert the plug into the power supply and turn
on the switch.
02
Advertisement
