Servicing The Hard Disk Drives And Power Supply - Honeywell T610 Planning, Installation And Service Manual

Chapter 5 - Servicing
To replace the LCNP4E board
1. Disconnect the LCN MAU cable from the LCNP4E card.
2. Remove the expansion card stabilizer located at the top.
3. Open the blue plastic expansion card retainer adjacent to the LCNP4E card in PCIE slot 5.
4. While wearing a grounded ESD wrist strap, grasp the LCNP4E card at the corners and gently
remove the existing card from the PCIE slot 5.
5. Insert the replacement LCNP4E card firmly into PCIE slot 5, until the card is fully seated.
6. Align the LCNP4E card edge connector with the card edge guide..
7. Install the screw that secures the assembly card bracket to the expansion slot cage. (The top of this
screw may be on the underside of the bracket.)
8. Close the blue expansion card retainer.
9. Replace the cover and bezel.
10. Reconnect the LCN MAU cable to the LCNP4E card.
11. Close the cover and bezel.
12. Replace the server in the cabinet.
13. Reconnect the power cords and cables to the back panel of the server.
14. Reconnect the LCN MAU cable.
15. Press the Power On/Off button on the server, to turn on the server.
5.4

Servicing the hard disk drives and power supply

The server from Honeywell is configured with 5, 146 GB SAS hard drives. Four are used in a RAID-5
ATTENTION
Do not route cables over or behind the cards. Cables routed over the cards can prevent
the system cover from closing properly or damage the equipment.
- 46 -