Behringer BCD-2000 Manual page 4

high equalizer knobs and kill switches.
The pitch bend + and – will temporarily bend the pitch of the track up or down for beat matching. As
soon as you release the button, the pitch will return to it's original value. The longer you hold the button,
the more the pitch will change.
Use the pitch slider to adjust the pitch of each deck. Note that this slider works relative to the current
pitch. Which means that you can use DEX/RED Mobile's auto beat match function, and then adjust the
pitch slightly with the pitch slider if necessary.
If you want to make very small adjustments to the pitch, you can also hold the To Top button and use
the Pitch Bend + and – buttons, to change the pitch by +-0.05%
With the search forwards/backwards buttons, you can scroll through the track. Pressing forward will
move the song position about 30 seconds forward, pressing backwards will move the song position
about 10 seconds backwards.
You can hold the fwd/bck search button to scroll through the song. The longer you hold them, the faster
it will skip.
The Sync Slave button will adjust the pitch to match the other decks' bpm. Holding the button for more
than a second and then releasing it will reset the pitch to 0%.
The Scratch button switches between all modes for the jog wheel. When the led is off, the jog wheel
can be used to bend the pitch up or down when the track is playing. When the track is paused, it will
move the cue point. When the led is on, the jog wheel can be used for scratching while the track is
playing. When the led is flashing, you can use the jog wheel to scroll through the playlist (see later).
You can use the Loop In/End button to start/stop a 4-beat loop. The led on the Loop Out button will
show if the loop is enabled or not.
Hold the Analog Input button for about a second to activate the line input on that deck. Note that on the
BCD, the Mic Input and Phono Input A are sharing the same input, so only one of the two can be used
simultaneously.
If you use DEX Vinyl Control features then you can activate/deactivate vinyl control by pressing To Top
and the Analog Input button simultaneously.
Use the On Air button to enable the mic. Internally, it will be loaded to DEX's' third deck, so by opening
it you can even apply any effect you want to the mic input on screen.
Use the Master/Split button to switch between hearing the master output through the headphones or
the cue output. Hold the button pressed for about a second to activate split mode, where one side of
open in browser PRO version pdfcrowd.com
Are you a developer? Try out the HTML to PDF API