Satellite System Guide - Samsung UE40F8000SL Service Manual

2-4-5. Satellite System Guide

Screen Menu > Broadcasting > Channel Settings > Satellite System
A set of satellite dish settings must be configured for each wanted satellite before performing a channel scan.
Satellite System is available when Aerial is set to Satellite.
NOTE
The PIN input screen appears. Enter your 4 digit PIN number.
• Satellite Selection : You can choose the satellites for this TV.
• LNB Power : Enables or disables the power supply for the LNB.
• LNB Settings : Configures the outdoor equipment.
Satellite: Selects the satellite for receiving digital broadcasts.
Transponder: Selects a transponder from the list or adds a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency.
Tone 22 kHz: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should be Auto.
• SatCR/Unicable Settings: Configure single cable installation.
NOTE
• SatCR is short for satellite channel router.
• This function may not support depending on the country.
SatCR/Unicable: Enables or disable single cable installation support.
Slot Number (Tuner 1), Slot Number (Tuner 2): Select the SatCR user slot number for this receiver.
Slot Frequency (Tuner 1), Slot Frequency (Tuner 2): Enter the appropriate frequency to receive the signal from
SatCR.
Detect Slot Frequency: Auto-detect the signal frequency for the selected slot number.
Verify Slot Frequency: Verify that the frequency entered corresponds to the selected slot.
• Positioner Settings
Positioner: Enables or disables the positioned control.
Positioner Type: Sets the positioned type between DiSEqC 1.2 and USALS (Universal Satellite Automatic Location
System).
My Longitude: Sets the longitude for my location.
-
My Latitude: Sets the latitude for my location.
-
Satellite Longitude Settings: Sets the longitude of user defined satellites.
-
User Mode: Sets the position of satellite aerial according to each satellite.
If you store the current position of satellite aerial according to a certain satellite, when the signal
of that satellite is needed, the satellite aerial can be moved to pre-populated position.
Satellite: Selects the satellite to set the position for.
-
Transponder: Selects a transponder from the list for signal reception.
-
Moving Mode: Selects the movement mode between discrete and continuous movement.
-
Step Size: Adjusts the step size degrees for the aerial rotation. Step Size is available when Moving Mode is set to
-
Step.
Go To Stored Position: Rotates the aerial to the stored satellite position.
-
Aerial Position: Adjusts and stores the aerial position for the selected satellite.
-
Store Current Position: Stores current position as the selected positioner limit.
-
: Configures the aerial positioner.
2. Product specifications
2-21