How To Start Over If You Can't Get Into The Router's Setup Menu Anymore - Asus RC-AC68U Manual

Low radiation wireless access point with jrs eco 100 wifi firmware
Table of Contents

Advertisement

After completing the Asus Setup Wizard as shown in the
screen shots on the next pages, come back to this page of the
manual to perform step 3.
Make sure not to skip step 3 because if you skip it, the
router will run the stock Asus firmware and will not be low
radiation!
Step 3: Now log back in to the router via router.asus.com. In the router
settings menu, click on Administration and then on the tab 'Firmware
Upgrade'. If the router proposes to upgrade the firmware, click on 'Cancel'.
You will now need the JRS Eco 100 firmware file that you downloaded from
www.jrseco.com/account
approximately 40MB in size.
Variant 1: Click on Choose File next to New Firmware File and select the
firmware file. Then click on Upload.
Variant 2: Click on Upload next to Manual Firmware Upload and select the
firmware file.
The router will install the Eco firmware and reboot. After 3 minutes the process
is complete. Congratulations! Your JRS Eco 100 firmware is now installed.
If the JRS Eco firmware has been uploaded correctly, the JRS logo should be
showing at the top of the router settings screen, when you log back in to the
router settings menu. Also, there should be a tab labeled 'JRS' on the
Wireless page, where you can adjust all Eco related settings. Here you can
also check the mode of the router. The first day, the router will be in Beacon
Eco mode (a.k.a. Learning mode). After one day it will switch to full Eco mode.
3.1. How to start over in case you can't get into the router's setup menu
anymore
If you can't remember what you set the administrator password to, and you
can't get into the
This will return all settings to the default values. Turn off the power to the
router and then turn it back on while keeping the WPS button pressed. When
the power light starts flashing rapidly, you can release the WPS button. It may
take up to 30 seconds until the light starts flashing. Then the router will restart,
which takes 3 minutes. If the JRS Eco firmware has already been installed, it
will remain on the router after resetting. The Asus setup wizard should now be
available again at
computer is connected directly to the Asus router (see earlier in this manual).
Gv J. v. Stolbergln 31 - A3850
2263AB Leidschendam
The Netherlands
+31 85 25 00 235
www.jrseco.com
info@jrseco.com
in step 1. This file has a '.trx' extension and is
router.asus.com
router.asus.com
Copyright 2020 JRS Eco Wireless – ECO-100 V5
page, you can reset the router as follows.
or at http://192.168.1.1, provided that your
6

Advertisement

Table of Contents
loading

Table of Contents