Sharp CD-M10000W Operation Manual page 11

! Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS
terminal and position the FM aerial wire in the di-
rection where the strongest signal can be re-
ceived.
Supplied AM loop aerial:
Connect the AM loop aerial wire to the AM
LOOP socket. Position the AM loop aerial for
optimum reception. Place the AM loop aerial on
a shelf, etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause noise pickup.
Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling >
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
75 ohm
coaxial
cable
Note:
When an external FM aerial is used, disconnect the supplied FM aerial wire.
! Speaker connection
Main speakers:
Connect the black wire to the MAIN (-) terminal, and the blue wire to the MAIN (+) ter-
minal.
Woofers:
Connect the black wire to the WOOFER (-) terminal, and the red wire to the
WOOFER (+) terminal.
Caution:
" Connect the speaker wires to the speakers first, then to the unit.
" Never mistake the MAIN and the WOOFER terminals. The unit or the speakers
may be damaged.
" Only the included speakers should be used with this product. Do not use other
speakers with this unit or use the supplied speakers with other units.
" Do not mistake the right and the left channels. The right speaker is the one on the
right side when you face the unit.
" Do not let the bare speaker wires touch each other.
" Do not allow any objects to fall into or to be placed in the bass reflex ducts.
< Attaching to the wall >
" Do not stand or sit on the speakers. You may be injured.
Wall Screws (not supplied)
External
FM aerial
Incorrect
01/10/1 CD-M10000W(X)E1.fm
CD-M10000W
ENGLISH
Incorrect
E-10
1
2
3
4
5
6
7