Sharp CD-DP2400E Operation Manual page 23

" Recording from the radio
1
Tune in to the desired station (see page 19).
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC/PAUSE ( )
button.
Recording will be paused.
4
Press the / button on the
main unit or the TAPE 2 but-
ton on the remote control to
start recording.
To interrupt recording:
Press the REC/PAUSE ( ) button.
To resume recording, press the / (TAPE 2
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tabs on cassette tapes:
! When recording on a cassette tape, make
sure that the erase-prevention tabs are not
removed. Cassettes have removable tabs
that prevent accidental recording or erasing.
! To protect the recorded sound, remove the
tab after recording. Cover the tab hole with
the adhesive tape to record on the tape with-
out the tab.
" Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
2
3
4
) button.
5
To stop dubbing:
Press the
TAPE 1 and TAPE 2 will simultaneously stop.
Side A
" Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
Tab for side B Tab for side A
2 Press the TAPE (1
3 Press the REC/PAUSE (
4 Press the
trol to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
Press the ON/STAND-BY button to turn the power on.
Load a prerecorded cassette into
the TAPE 1 cassette compart-
ment. Insert a blank tape into the
TAPE 2 cassette compartment.
It is recommended that the recording
tape is the same length as the master
tape.
Press the TAPE (1 2) button un-
til "TAPE 1" appears on the dis-
play.
Press the REC/PAUSE ( ) but-
ton.
Recording will be paused.
Press the / button on the
main unit or the TAPE 2 button
on the remote control to start
dubbing.
(TAPE ) button.
2) button until "TAPE 2" appears on the display.
) button.
/ button on the main unit or the TAPE 2
01/7/17 CD-DP2400E_3.fm
CD-DP2400E
button on the remote con-
23