Setting The Baud Rate; Displaying Calibration Values - American Dynamics ADTTE Installation Instructions

Setting the Baud Rate

The AD T T supports four baud rates:
OUCH RACKER
1200, 2400, 4800, and 9600 baud. The default
setting for the baud rate is 1200.
Note: The T T
OUCH RACKER
the baud rate incorrectly. Be sure that the baud
rates for the T T
OUCH RACKER
the same value.
1. Use the number buttons to enter the baud rate
(1200, 2400, 4800 or 9600).
2. Press F1 (located to left of the LCD).
No prompts appear on the screen to inform you
that the baud rate has been changed.
Tracker Ball Calibration
1. Press the Calibrate button.
The following message appears on the LCD:
Push Tracker Ball Left
2. Push the Tracker Ball to the left.
The following message appears on the LCD:
Push Tracker Ball Right
3. Push the Tracker Ball to the right.
The following message appears on the LCD:
Push Tracker Ball Down
4. Push the Tracker Ball towards you.
The following message appears on the LCD:
Push Tracker Ball Up
5. Push the Tracker Ball away from you.
The following message appears on the LCD:
Release Tracker Ball
6. Release the Tracker Ball.
Calibration is complete.
4 8000-1658-02, Rev. C
will not operate if you set
and switch are set to
AD T
Installation Instructions

Displaying Calibration Values

1. Use the number buttons to enter 34, then press
Calibrate.
Information similar to the following will appear
on the LCD:
LD2 R00 UD6 D9D
10 10
2. Press LCD Clear to refresh the LCD.
Selecting LCD Language
The T T supports a number of different
OUCH RACKER
languages including:
English
French
German
To change the language of prompts appearing on
the LCD, do the following:
1. Use the number buttons to enter 35, then press
Calibrate.
2. Use the Next button to scroll through the
available languages.
3. Press Ack (Enter) when the correct language
appears on the LCD.
The T T resets. All future messages on
OUCH RACKER
the LCD will appear in the selected language.
Displaying the Firmware
Version
1. Use the number buttons to enter 100, then
press F1.
The firmware information appears on the LCD.
F 0701-2490-0100
E 0701-2491-0100
The information appearing after the "F" is the
Flash version.
The information appearing after the "E" is the
EEPROM version.
2. Press LCD Clear to refresh the LCD.
T
OUCH RACKER
10 10
Italian
Portuguese
Spanish
American Dynamics