2. Mount both of the Rails on the braces inside of the TM Mobile Workstation with M4*6mm Flat Screws to the
respective holes as shown.
3. Put the control box on both of Rails of the TM Mobile Workstation as shown below, and then secure the
control box with both of Brackets A, both of Brackets B, M4*6mm Combination Flanged-Hex/Phillips-Head
Screws, and the screws removed from the hand grips. You can press the left side of the side panel to open it
and tighten the screws better, and leave it opened for cable routing such as the Ethernet cable.
TM Mobile Workstation Manual
Holes for M4*6mm Flat Screws
10