Cisco TelePresence SX10 Quick Set
Introduction
NetworkServices SSH Mode
SSH (or Secure Shell) protocol can provide secure encrypted communication between the
codec and your local computer.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH protocol is disabled.
On: The SSH protocol is enabled.
NetworkServices SSH HostKeyAlgorithm
Choose the cryptographic algorithm that shall be used for the SSH host key. Choices
are RSA (Rivest–Shamir–Adleman) with 2048 bits keysize, ECDSA (Elliptic Curve Digital
Signature Algorithm) with NIST curve P-384, and EdDSA (Edwards-curve Digital Signature
Algorithm) with ed25519 signature schema.
Requires user role: ADMIN
Default value: RSA
Value space: ECDSA/RSA/ed25519
ECDSA: Use the ECDSA algorithm (nist-384p).
RSA: Use the RSA algorithm (2048 bits).
ed25519: Use the ed25519 algorithm.
NetworkServices SSH AllowPublicKey
Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.
D15330.14 SX10 Administrator Guide CE9.7, APRIL 2019.
Configuration
Peripherals
Maintenance
NetworkServices Telnet Mode
Telnet is a network protocol used on the Internet or Local Area Network (LAN) connections.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The Telnet protocol is disabled. This is the factory setting.
On: The Telnet protocol is enabled.
NetworkServices UPnP Mode
Fully disable UPnP (Universal Plug and Play), or enable UPnP for a short time period after
the video system has been switched on or restarted.
The default operation is that UPnP is enabled when you switch on or restart the video
system. Then UPnP is automatically disabled after the timeout period that is defined in the
NetworkServices UPnP Timeout setting. Use the video system's web interface to set the
timeout.
When UPnP is enabled, the video system advertises its presence on the network. The
advertisement permits a Touch controller to discover video systems automatically, and
you do not need to manually enter the video system's IP address in order to pair the Touch
controller.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: UPnP is disabled. The video system does not advertise its presence, and you have
to enter the video system's IP address manually in order to pair a Touch controller to the
video system.
On: UPnP is enabled. The video system advertises its presence until the timeout period
expires.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
123
Administrator Guide
System settings
System settings
Appendices