Download Print this page

Pentair Hoffman IW4000 Manual

Ir window

Download this manual

Usage notes

For use on a flat surface of a type 4/12 enclosure

Failure to follow these instructions may lead to damage or injury. Comply with local and

national safety requirements when working in hazardous locations.

Before you start

The installation may be carried out by using either a circular hole saw or a hydraulic hole

punch.

Tools required:

1. Hydraulic punch or hole saw (95 mm - 95.5 mm (3-3/4 in.))

2. Drill

3. Conedrill

4. Pozidrive screwdriver

5. Center punch

6. 6 mm (1/4 in.) drill bit

7. 3.6 mm (9/64 in.) drill bit

Getting started

Unpack and check

STEP

When your Infrared Window arrives, carefully unpack

the unit and check contents:

1. IW4000 unit (1)

2. Fixing screws (4)

3. Drilling template (1)

Rev. A

IW4000

IR Window

PH 763 422 2211

pentairprotect.com

P/N 89116262

89116261

Page 1 STEP When your Infrared Window arrives, carefully unpack the unit and check contents: 1. IW4000 unit (1) 2. Fixing screws (4) 3. Drilling template (1) Rev. A © 2014 Pentair Equipment Protection PH 763 422 2211 pentairprotect.com P/N 89116262 89116261...
Page 2 Using the center punch, punch the fixing holes as marked and center hole. Center hole STEP 4 STEP Using the 6 mm (1/4 in.) twist drill, drill out the center hole (B). - 2 - © 2014 Pentair Equipment Protection PH 763 422 2211 pentairprotect.com 89116261...
Page 3 Proceed to step 7. Enlarging the center hole (hole punch) STEP 6b STEP Refer to the hydraulic punch manual and follow all safety procedures. Proceed to step 7. 89116261 © 2014 Pentair Equipment Protection PH 763 422 2211 pentairprotect.com - 3 -...
Page 4 Usage notes To maintain enclosure type rating, viewport cover must be secured in place. All Pentair trademarks and logos are owned by Pentair or its global affiliates. Pentair reserves the right to change specifications without prior notice. © 2014 Pentair.