Removing The Mask - ResMed Mirage Quattro User Manual

1 Twist the forehead support dial to Position 24, where the forehead support
is fully extended (Fig. B-1).
2 Hold the mask steadily on your face (Fig. B-2) and pull the headgear over
your head.
3 Bringing the lower straps below your ears, clip the headgear to the lower
part of the mask frame (Fig. B-3).
4 Unfasten the Velcro
comfortable and firm, and reattach the Velcro (Fig. B-4).
5 Repeat step 4 with the lower headgear straps (Fig. B-5).
6 Test the functioning of the valve by sealing the swivel with your hand and
ensuring that you can still breathe freely.
7 Connect the main air tubing to the swivel (Fig. B-6). Then connect the free
end of the air tubing to your flow generator and turn the flow generator on.
8 Lie down in your sleeping position. Twist the forehead support dial
(Fig. B-7) until you feel that the mask is evenly positioned on your face. It
should be comfortable, with a satisfactory seal. Gently tighten the lower
headgear straps if necessary.
9 The fitted mask is shown in Fig. B-8.
Optimizing Mask Seal and Comfort
To receive effective therapy it is important to have the best seal possible
between your mask and your face. If you are experiencing leaks, please ensure
that you have followed the fitting instructions carefully. Carry out a quick check
after fitting your mask:
•
Is the mask cushion creased? Creases can allow air to leak out of the mask.
•
Have you cleaned your mask cushion recently? Oils on the cushion can
affect the seal.
•
Are your headgear straps overtightened? Try not to alter the upper headgear
straps once they have been tightened by your clinician.
•
You may need to slightly adjust the dial. Note the dial setting when
comfortable.
•
Does the mask seem too close to your eyes? You may need a smaller mask.
If you cannot resolve any problems, look at the Troubleshooting section, or talk
to your clinician. You may require another mask size.

Removing the Mask

To remove the Mirage Quattro, disconnect one of the lower headgear clips and
pull the mask and headgear up over your head.
®
, pull the upper headgear straps evenly until they are
3