Special Mode - Denon AVR-X4000 Service Manual

SPECIAL MODE

Special mode setting button
b No.1 - 5, 7, 8 : Press the "Power operation ( X )" button to turn on the power while pressing both the buttons A and the button B at the
same time.
b No.6 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
No. Mode
Version display
1
(μcom/DSP Error Display)
User Initialization mode
2 (Installer Setup settings are not
initialized.)
Factory Initialization mode
3 (Installer Setup settings are also
initialized.)
PANEL/REMOTE LOCK Selection
4
mode
5 Service Related Selection mode
6 Remote ID Setup mode
Mode for switching tuner frequency
7 step
(E2 model Only)
8 Installer Setup mode
Button A Button B
SETUP OPTION
INFO BACK
Cursor d Cursor f
STATUS INFO
ZONE3
STATUS
SOURCE
DIMMER STATUS
OPTION BACK
Cursor 0 BACK
STATUS
INFO
BACK
ZONE3 SOURCE Cursor
X
20
Contents
Firmware versions such as Main or DSP are
displayed in the FL Display. Errors are displayed
when they occur. (Refer to
Backup data initialization is carried out.
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
(Installer Setup settings are also initialized.)
Selects to reject operations through panel buttons
and the master volume knob on the main unit and
operations via the remote control.
Selects the "Diagnostic mode" or "Displaying the
protection history mode". (Refer to
When using multiple DENON AV receivers in
the same room, make this setting so that only
the desired AV receiver operates. (Refer to
page)
Change tuner frequency step to FM:50kHz/200kHz
Access the Remote Maintenance mode via the
internet.Installer Setup is displayed on GUI/Option
Menu.
b Refer to AVR_RemoteMaintenance_.pdf of SDI.
DIMMER
OPTION
SETUP
22 page)
66 page)
69