Rear Panel Operation - Alesis Transactive 50 Quick Start Owner's Manual

Channel 1 / Mic In –
1.
this input using an XLR cable.
Channel 1 / Line In –
2.
synthesizers, drum machines, and other devices.
For mono sources, use whichever input you'd like.
Headphones –
3.
¼" stereo plug. Using the headphone jack
disconnects the TransActive's internal speaker.
Power –
4. This switch turns your TransActive 50 on and off. When you turn on
the speaker, the blue light bar above the front panel will illuminate.
Power Cord Outlet
5.
into this jack and into a properly grounded AC outlet.
The TransActive's internal power supply automatically
adjusts to any voltage worldwide.
Channel 2 –
6. Use ¼" cables to connect synthesizers,
drum machines, and other devices. For mono sources,
use whichever input you'd like.

Rear panel operation

Plug a microphone into
Use ¼" cables to connect
Plug in your headphones using a
– Plug a standard IEC power cable
Channel 1 Inputs
You cannot use the ¼" and
XLR inputs at the same time.
Once you plug ¼" connectors
into the TransActive 50, the
XLR input will become
inactive.
Balanced vs. Unbalanced
For the cleanest signal, use
"balanced" tip-ring-sleeve
(TRS) cables. "Unbalanced"
tip-sleeve (TS) cables may
also be used, but they are
more likely to conduct hum
and other electromagnetic
noise.
3