Download Print this page
Aiwa XP-V7230 Operating Instructions
Aiwa XP-V7230 Operating Instructions

Aiwa XP-V7230 Operating Instructions

Aiwa xp-v7230: operating instruction
Hide thumbs Also See for XP-V7230:

Advertisement

Quick Links

XP-V7230
COMPACT DISC PLAYER
REPRODUCTOR DE DISCOS COMPACTOS
OPERATING INSTRUCTIONS
INSTRUCCIONES DE MANEJO
MODE D'EMPLOI
NOTE
FOR USE IN THE U.S.A.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Modifications or adjustments to this product, which are not expressly approved
by the manufacturer, may void the user's right or authority to operate this product.
A
B
C
1
3
8B-HC4-911-01
001221AYO-O9
Printed in Indonesia
AA(LR6)
2
OWNER'S RECORD
For your convenience, record the model number and the serial number (you will
find it inside the battery compartment of your set) in the space provided below.
Please refer to them when you contact your Aiwa dealer in case of difficulty.
Model No.
Serial No.
Highlighted letters in the text of this manual correspond to the illustrations.
PRECAUTIONS
To maintain good performance
• Do not use the unit in places which are extremely hot, cold, dusty or humid. In
particular, do not use or keep the unit in following places.
• in a high humidity area such as a bathroom
• near a heater
• in an area exposed to direct sunlight (e.g., inside a parked car, where it can
become extremely hot)
• near sources of strong magnetism, such as televisions, speakers, or magnets
• where there is a lot of movement or vibration, such as on a car dashboard or an
unstable shelf
For safety
• Do not attempt to disassemble the unit. Laser rays from the optical pickup are
dangerous to the eyes.
• Make sure that pins or other foreign object do not get inside the player.
• Take care not to drop the unit or subject it to strong shocks.
• To keep dust from the pickup lens, keep the disc compartment lid closed after
use. Never touch the lens.
• If you hear no sound when playing a disc, DO NOT turn the volume up high
because music could suddenly start at high volume. Turn the volume control to
the lowest level before starting playback and slowly turn it up to the desired level.
Note on listening with the headphones
• Listen at moderate volumes to avoid hearing damage.
• Do not wear the headphones while driving or cycling. It may create a traffic
hazard.
• You should use extreme caution or temporarily discontinue use in potentially
hazardous situations, such as walking, jogging, etc.
• Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in
condensation on the pickup lens and malfunction or playback difficulties.
Should this occur, leave the unit for a few hours, then try to playback again.
USING ON DRY CELL BATTERIES
Open the battery compartment and insert two size AA (LR6) alkaline batteries
with the 0 and 9 marks correctly aligned.
Battery replacement
The battery indicator in the display changes from
2
the remaining power of the batteries. Replace the batteries when
the unit remains in use after
will stop.
Battery life (using alkaline batteries LR6)
The setting of the E•A•S•S switch
48
12
OFF
Battery life may vary depending on conditions of use.
If the cover of the battery compartment comes off
Note on dry cell batteries
• Make sure that the 0 and 9 marks are correctly aligned.
• Do not mix the different types of batteries, or an old battery with a new one.
• To prevent the risk of electrolyte leakage or explosions, never recharge the
batteries, apply heat to them, or take them apart.
• When not using the batteries, remove them to prevent needless battery wear.
• If liquid leaks from the batteries, wipe thoroughly to remove.
USING ON RECHARGEABLE BATTERIES
• Be sure to use only size AA Ni-Cd 1.2 V rechargeable batteries, which are
commercially available.
• Be sure to read the instructions of the purchased rechargeable batteries before
use.
• When using on rechargeable batteries for the first time, charge them until the
battery indicator goes out.
• Before charging the batteries, close the disc compartment. You cannot charge
the batteries while it is opened.
1 Insert the rechargeable batteries with the 0 and 9 marks correctly aligned.
2 Connect the AC adaptor.
1 to DC 5~6 V jack
2 to a wall outlet
3 Keep sSTOP/OFF/CHARGE pressed for about 2 seconds to start charging.
"C-on" appears and the battery indicator blinks.
ENGLISH
A
to
to
lights, "Lo-bAtt" is displayed and the operation
Battery life
Approx. 32 hours
Approx. 22 hours
Approx. 22 hours
B
according to
lights. If
C

Advertisement

loading

Summary of Contents for Aiwa XP-V7230

  • Page 1 For your convenience, record the model number and the serial number (you will find it inside the battery compartment of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. Model No.
  • Page 2: Using On Ac House Current

    OPEN 1 Insert the rechargeable batteries with the 0 and 9 marks correctly aligned. 2 Connect the AC adaptor. 1 to DC 5~6 V jack 2 to a wall outlet 3 Keep sSTOP/OFF/CHARGE pressed for about 2 seconds to start charging. “C-on”...
  • Page 3: Program Play

    HOLD RESUME ENGLISH PLAYBACK Connect the supplied headphones to the PHONES/LINE OUT jack. The amplified speaker system can be connected instead to enjoy the CD sound. 1 Release HOLD. 2 Place a disc. 3 Press ePLAY/PAUSE. Playback starts from the first track. a track number b elapsed playing time Basic operation...
  • Page 4: Specifications

    Up to 24 tracks can be chosen for program play. 1 Press DISPLAY/ENTER while in standby mode to display 2 Select the desired track by pressing r and t. a track number b program number 3 Press DISPLAY/ENTER within 8 seconds. If it is not pressed within 8 seconds, the track number changes to 00.