Advertisement
Alignment and Adjustments
4-13 Factory Adjustment
4-13-1 Factory/Service Mode
1. To enter the Service Mode, press the remote control buttons in the
following sequence :
Power OFF (about 10 seconds later) ® MUTE ® 1 ® 8 ® 2
Power ON ® Display ® Factory
2. After the Factory Adjustment Mode is entered, the initial screen
is as shown in the figure below.
11
SERVICE MODE
GEOMETRIC
PICTURE
SOUND (FIXED)
PIP (FIXED)
OPTION (BYTE 1 : 60, BYTE 2 : 02)
READ
RESET
3. Use the Channel Up/Down ( / ) buttons to move the cursor
on the adjustment parameters.
Note :
1. When CRT, EEPROM, FBT, or MICOM is replaced, the adjustment
values should be controlled.
2. After the Factory Adjustment is completed, be sure to reset the
TV set.
4-6
Not Used
CH NO.
Samsung Electronics
Advertisement
