AcuRite 08575 Instruction Manual page 4

Setup- Weather Station
Now that setup is complete, you must choose a location to place the
wireless sensor and the weather station. The wireless sensor MUST be
placed less than 330 feet ( 100 meters) away from the weather station.
This product uses radio frequency for communication, which is
susceptible to interference from other electronic devices and large
metallic items or thick walls. Always place both units at least 3 feet (. 91
m) away from aBpliances ( TV, microwave, radios, etc. ) or obiects that
may interfere w1tli the wireless communication ( large metal surfaces,
thick stone walls, etc. ).
-
- -'o'' ...
-
; I \'
AT
ILEASTI
3
feet
1.91ml
APART
[330 feet maximum]
[100 meters]
Placement of Weather Station
Place the weather station in a dry area free of dirt and dust on
a table top or other flat surface. Keep the display
unit/weather radio away from moisture. Choose a location at
least 3 feet away from other electronics for best wireless
operation and reception of the NOAA weather radio signal.
Placement of Sensor
The wireless sensor MUST BE PLACED OUTDOORS to observe
outdoor temperatures. The wireless sensor must be placed less
than 330 feet ( 100 meters) from the weather station. The
wireless sensor is water resistant and is designed for general
outdoor use. However, to extend the life of the product, P.lace
the wireless sensor in an area protected from direct weather
elements. To ensure an accurate outdoor temP.erature
measurement, be sure the wireless sensor is placed out of
direct sunlight and away from any heat sources.
There are 2 placement options for the wireless sensor. You may
hang it using one of the two integrated hang holes, or use
string (not included) to hang it from a suital:ile location like a
well covered tree branch.
4
■
Setup- Weather Station
About the Self Setting lntelli-Time® Clock
This product is equipped with lntelli-Time® technology which is
pre-programmed with the correct time and date. lntelli-Time®
technology instructs the clock and calendar to set itself once batteries
are installed. All you need to do is select your Time Zone and Daylight
Saving Time preferences. The clock will automatically set itself and
change automatically for Daylight Saving Time.
Weather Station: Basic Setup
Press AND HOLD the "SET" button for
5
seconds to enter into basic set
mode. The time zone (default is EST) will begin blinking.
To adjust the currently selected (flashing) preference item, press and
release the ",.." or " ... " buttons. To save your adjustments, press and
release the "SET" button again to move on to adjusting the next
preference. The preference set order is as follows:
TIME ZONE ( PST MST CST EST AST HAST AKST)
AUTO DST (Daylight Saving Time ON or OFF)
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
UNITS (°For
0
C)
You will automatically exit SET MODE and into normal operaton mode
if no entries are changed for 30 seconds. You may enter basic setup
mode again at any time by pressing AND HOLDING the "SET" button.
DAY/MONTH DISPLAY OPTIONAL
The calendar alphanumeric display area can display either the DAY
(FRI) or the MONTH (AUG). Press and release the "SET" button when
in normal operation mode to switch between DAY or MONTH display.
5