Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Measuring tape
Pencil
■
■
7/64" drill bit
Drill
■
■
Screw Pack Supplied (not shown to scale)
SCREW
#7-18x7/16" round-head sheet metal
screw
#7-16x15/16" flat head wood screw
#7-16x7/16" round-head wood screw
NOTE: There are some extra screws in the screw pack. They are
spares for your use during installation if needed. See below:
#7-18x7/16" round-head sheet metal screw: 4 extra.
■
#7-16x15/16" flat head wood screw: 2 extra.
■
#7-16x7/16" round-head wood screw: 4 extra.
■
Parts Supplied (not shown to scale)
This installation instruction is for various models. Some parts
supplied may have different appearance, depending on your
model.
NOTE: Trim kit frame (1), Cooling Ducts (2) and Rail (2) parts will
need to be purchased to convert from Standard to Slim or from
a Slim to a Standard installation.
Parts supplied for model: WMT50011K and KMBT5011K
PART
Trim kit frame (slim)
Cooling duct (slim)
Rail (slim)
2
INSTALLATION REQUIREMENTS
Phillips screwdriver
■
SCREW ART QTY
PART ART
QTY
1
2
2
Parts supplied for model: WMT55511K and KMBT5511K
PART
Trim kit frame
(standard)
Cooling duct (standard)
Rail (standard)
14
6
Parts supplied for all models
PART
10
Turntable
Turntable ring
Turntable driver
NOTE: The turntable driver is located inside the microwave oven
cavity. Remove the tape before use.
PART ART
PART ART
QTY
1
2
2
QTY
1
1
1