Advertisement
OPERATION
OSCILLATION: Push down oscillation knob on motor housing
to make fan head move from side to side. (Figures 8 and 9)
Up: Stationary
Down: Oscillate
Figure 8
Figure 9
SPEED: Control fan speed with Speed Knob. (Figure 10)
3 - High Speed
2 - Medium Speed
1 - Low Speed
Speed
Knob
Figure 10
TILTING: This Fan is equipped with a multi-angle Fan Head
for Whole-Room Air Circulation. Follow the steps below to prop-
erly adjust the "tilt angle" of your Fan.
1. Place one hand just under the Fan Neck.
2. Place your other hand on top of Fan.
3. Gently push or pull the Fan Head until it is in the desired
position.
Rev. C 8/05
MAINTENANCE
WARNING:
ALWAYS
UNPLUG CORD BEFORE
CLEANING OR DISASSEMBLING.
WARNING:
DO NOT IMMERSE FAN IN WATER!
CLEANING: IMPORTANT! DO NOT immerse electrical parts
in water! Disassembled grills may be immersed to be cleaned
with a mild detergent and water. Wipe all other parts with soft
cloth moistened with water and mild detergent only. DRY ALL
PARTS COMPLETELY BEFORE REASSEMBLING. After
any maintenance or servicing, completely reassemble unit as
described in this instruction manual before reconnecting to the
power supply.
CAUTION:
Do not use gasoline, benzine, thinner, harsh
cleaners, etc. as they will damage the Fan. NEVER use
ALCOHOL OR SOLVENTS.
SERVICING: All other servicing, with the exception of gen-
eral user maintenance, should be performed by an authorized
service representative. Call 1-800-233-0268, Monday through
Friday, between the hours of 8:00 a.m.and 5:00 p.m. EST for
the location of your nearest service center.
LUBRICATION: Motor is permanently lubricated.
4
CONVERTING FROM TABLE FAN TO WALL MOUNTED FAN
SMALL
ADJUSTMENT
KNOB
3. Tilt Motor Housing all the way back.
4. Reinstall Small Adjustment Knob and tighten.
5. Reinstall Large Adjustment Knob.
6. Install two #8 x 1 1/4" Wood Screws ( not provided ), using Template below, leaving 1/8" between Screwheads and wall.
7. Mount Fan over Screws using Slotted Holes on Bottom Plate.
NOTE: TO ADJUST HEAD VERTICALLY - Loosen Large Adjustment Knob, set Motor Housing, retighten Knob.
CAUTION: FAN IS UNSTABLE IN THIS POSITION AND CANNOT BE USED AS A TABLE FAN.
TEMPLATE -
NOT SUPPLIED - Two #8x1-1/4" Wood Screws (Must be purchased separately)
NOTE: BE SURE THAT THE MOUNTING SCREWS ARE INSTALLED IN A WALL STUD FOR MAXIMUM SUPPORT.
Rev. C 8/05
2084537
(Grills and blade removed for clarity)
MOTOR
HOUSING
NECK
STAND
1. UNPLUG FAN FROM OUTLET.
2. Remove the Small and Large Adjustment Knobs.
DETACH TEMPLATE AND TURN 90 ° for use...
7"
5
LARGE
ADJUSTMENT
KNOB
(For minor adjustments)
1/8"
2084537
Advertisement
