Level Control; Power Led - Peavey P BT Series Specifications

Input Panel
(1) XLR Mic Input (Ch 1&2)
Use this XLR connector to connect a microphone to the P1/2/3BT speaker.
(2) Line Input (Ch 1&2)
Use this 1/4" (6.5mm) connector to connect a line-level source to the P1/2/3BT speaker. The line input is typi-
cally used for sources like keyboards and CD players.
(3) RCA and 3.5mm Input (Ch 3)
These inputs, RCA and 3.5mm (1/8") accept a stereo input from the output of an MP3 player, CD player, phone
or similar device.
(4) 3.5mm/RCA Input Selector (Ch 3)
This switch selects the source being sent to channel 3. In the upper position, the RCA inputs are sent to channel
3. In the lower position, the 3.5mm (1/8") connector is sent to channel 3.

(5) Level Control

Use this to adjust the source level in the corresponding channel.
(6) Low EQ (Bass)
This is an active tone control (shelving type: +/-15dB) that varies the level of the low frequency range.
Caution: Excessive low frequency boost causes greater power consumption and increases the possibility of
speaker damage.
(7) High EQ (Treble)
This is an active tone control (shelving type: +/-15dB) that varies the level of the high frequency range.
(8) Master Volume
The master volume control adjusts the overall level of the speaker.

(9)Power LED

LED illuminates when power has been applied to the speaker.
(10) Sync XLR In/Out
The sync XLR In/Out connectors are used to daisy chain multiple speakers. Using these inputs, the signal source
can be fed to multiple speakers, while allowing the level of each speaker to be set by its own master volume con-
trol independent from the other speakers in the chain.
(11) Subwoofer Out
This 1/4" jack can be used to drive an external subwoofer amplifier or a power sub. The signal level is pre-master
volume control. This allows the user to balance the signal between the speaker and the subwoofer.
6
PAIRING
STEREO LINK
IN
10
Bluetooth Pairing
1. Press mode button to enter the BT pairing mode.
2. Connect your Bluetooth device to P1 BT.
Stereo Linking Two Speakers
1. Pair your Bluetooth device to rst speaker.
2. Press Pairing on the second speaker to turn BT on.
3. Press Stereo Link on both speakers under BT Mode.
4. To disconnect ,press the Stereo Link button again
While Pairing or Linking LEDs will ash.
When Paired or Linked LEDs will be solid.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
P1 BT
Subwoofer Out
OUT
SYNC
POWER
11
on either speaker.
9