Removing/Inserting The Battery; Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery - Parkside PABS 20-Li E6 Translation Of The Original Instructions

Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
• Only charge with the originally sup-
plied charger.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Online-Shop
(www.grizzly-service.eu).
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (1) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the battery
(4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (4) when
the red LED on the charge status
indicator (3) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
The charging time is around 1 hour
(PAP 20 A1).
1. Remove the battery (4) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (4) in the charging
compartment of the battery charger (5).
3. Plug the battery charger (5) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (5) from the
mains.
5. Remove the battery (4) from the charg-
er (5).
GB IE
19