Advertisement
Quick Links
TRBOnet Swift A200
World HQ
US Office
Neocom Software
Neocom Software
8th Line 29, Vasilyevsky Island
15200 Jog Road, Suite 202
St. Petersburg, 199004, Russia
Delray Beach, FL 33446, USA
Radio-over-IP Gateway
How to Reset
Internet
Email: info@trbonet.com
WWW.TRBONET.COM
Telephone
EMEA: +44 203 608 0598
Americas: +1 872 222 8726
APAC: +61 28 6078325
Advertisement
Summary of Contents for Neocom TRBOnet Swift A200
- Page 1 Radio-over-IP Gateway TRBOnet Swift A200 How to Reset World HQ US Office Internet Telephone Neocom Software Neocom Software EMEA: +44 203 608 0598 8th Line 29, Vasilyevsky Island 15200 Jog Road, Suite 202 Email: info@trbonet.com Americas: +1 872 222 8726 St.
- Page 2 This document is for informational purposes only. Neocom software, Ltd offers no warranties, express or implied, in this document. Neocom and the Neocom logo, TRBOnet and the TRBOnet logo are either registered trademarks or trademarks of Neocom software, Ltd. MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC.
- Page 3 How to reset Swift A200 If Swift A200 connected to the PC with a micro-USB cable doesn't display any information, or the device configuration cannot be retrieved by means of Swift CPS, just perform the following steps: Dismount the housing by unscrewing four screws on the rear •...
- Page 4 To restore the firmware of Swift A200, use the appropriate version of Swift CPS (1.9.0.18 or higher) Note that the computer must be connected to the Internet to automatically install STM32 microcontroller drivers. Carefully disassemble the board assembly of Swift A200: •...
- Page 5 For further diagnostics, connect the OLED board to the CPU • board. o On the CPU board disconnected from the USB cable, use tweezers or a reliable short-wire jumper to short-circuit the two VIA-contacts located next to the battery. o While keeping the contacts short-circuited, connect the CPU board via a USB cable to your PC with the installed Swift CPS.
- Page 6 Once the device is detected by the PC as "STM32 Bootloader" or "STM Device in DFU Mode", the short-wire jumper may be removed (disconnected). o Restore the firmware using Swift CPS, "Device > Upgrade Firmware". Once the process is completed the device will restart and display the correct service information.
- Page 7 If the CPU board doesn't start correctly or the Memory Card icon • is flashing on the OLED display, proceed with formatting the SD card (see Appendix 1). Note that a correct start means that service information is shown on the OLED display and the device configuration can be successfully retrieved by means of Swift CPS.
- Page 8 Appendix 1 Format the SD card in the PC. • o Use the Full Format mode (the Quick Format box is not checked) o Use one of the following file systems: exFAT, NTFS, or Ext2/3 The FAT 16/32 file systems are not supported in Swift A200. Warning! You need to format the SD card only in cases when the device doesn’t start with the inserted SD card but successfully starts...