Hardware Installation - Advantek Networks APS-U3100 User Manual

Blinking (Orange)
USB2 Blinking (Green)
Blinking (Orange)
Before you start, you should prepare the following items:
One Windows-based computer with print server setup CD
One printer
One printer cable

Hardware Installation

To install the print servers, you need to complete these steps:
˙Confirm that your printer parallel port or USB Port works well.
˙Connect the print server to the network and printer, and plug in the print server.
Follow these instructions to install the print servers, please refer to any
peripheral you are connecting to the print server:
1. Turn off the printer's power.
2. Connect the print server to your printer with printer cable.
3. Turn the printer's power on.
4. Plug the AC power adapter into the power connector on the print server.
5. Wait 10 seconds until all the LEDs have stopped flashing.
Note: The Status LED should be flash five times when POST. If not, please contact your local
dealer for repair or replacement.
PARALLEL is Port 1(PID1)
USB1 is Port 2(PID2)
Data is being transmitted via USB Port at USB 1.1.
Data is being transmitted via USB Port at USB 2.0.
Data is being transmitted via USB Port at USB 1.1.
REAR PANEL