Intermatic PA119 Mounting Instructions

Spring Grove, Illinois 60081
www.intermatic.com
Wall/Post Mounting Bracket
Model PA119
(For use with COMBOConnect™ PJBX52100)
Installation manual
SAFETY SECTION
Warning
Risk of Fire or Electric Shock
• Installation and/or wiring must be in accordance with all national and
local code requirements.
• For use with approved Intermatic junction boxes.
• Install the mounting bracket in accordance with the location instructions
supplied with the junction box being mounted on the bracket.
PACKAGE CONTENTS
• Mounting bracket
DIMENSIONS
1 5/8"
3 1/4"
7 3/4"
Wall/Post Mounting Bracket, Model PA119
WALL
4 1/4"
7 7/8"
1 5/8"
3 1/4"
MOUNTING INSTRUCTIONS
Wall Mount
FIG. 1. Wall or Post Mount
1. Determine the installation method.
For a wall-mount installation
(Refer to Fig. 1, Wall Mount):
– Hold the bracket up to the wall at the mounting
location. Ensure the bracket is level and located in
an area where it can be attached to the wall studs.
– Use the appropriate hardware (not included) to
attach the bracket to the wall surface.
For a post-mount installation
(Refer to Fig. 1, Post Mount):
– Place the bracket in a level position on the top of a
2"x4" or 4"x4" post that is secured into the ground.
– Use the appropriate hardware (not included) to
attach the bracket to the post.
FIG. 2. Placing the Junction Box
2. Place the junction box onto the mounting bracket so
that the front tabs on the mounting bracket slide into
the slots on the front of the junction box. Refer to Fig. 2.
1
Post Mount