Operation - CEN-TECH 57209 Owner's Manual & Safety Instructions

Operating Instructions
Using the Work Light
1. To turn the Work Light on, press the Power Button
ON and then press the Work Light button.
2. To turn the Work Light off, press
the Work Light button again.
Jump-Starting a Vehicle
note: Read the vehicle owner's manual pertaining
to jump-starting prior to using the Jump Starter.
1. Press the Power Button ON and check the Battery
Status Indicator Lights to verify that the Jump
Starter is fully charged. Recharge as needed,
following the instructions in the "Charging
the Jump Starter" section on page 7.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Switch on the Jump Starter
to the OFF position. You may leave
the Work Light on if needed.
WARnInG! TO PREVEnT SERIOUS InJURY:
DO nOT TOUCH POSITIVE AnD nEGATIVE
BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle's positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.
Running/Charging USB Devices
1. Press the Power Button ON and check the Battery
Status Indicator Lights to verify that the Jump
Starter is fully charged. Recharge as needed,
following the instructions in the "Charging the
Jump Starter" section on page page 7.
Page 8 For technical questions, please call 1-888-866-5797
3. If finished using the Jump Starter,
press the Power Button OFF.
WARnInG! TO PREVEnT SERIOUS InJURY:
DO nOT COnnECT TO THE nEGATIVE
TERMInAL OF THE BATTERY.
WARnInG! TO PREVEnT SERIOUS InJURY: DO
nOT TURn CLAMP SWITCH TO On POSITIOn
IF THE REVERSE POLARITY WARnInG LED
IS On AnD THE ALARM BUZZER IS HEARD.
STOP AnD CORRECT THE PROBLEM.
4. When the correct connection has been made,
turn the Clamp Switch to the ON position.
5. WAIT FIVE MInUTES, then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
nOTICE: THE VEHICLE WILL nOT START IF
YOU DO nOT WAIT AT LEAST 5 MInUTES.
6. After the vehicle is started, turn the
Clamp Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB Port.
4. If finished using the Jump Starter,
press the Power Button OFF.
Item 57209