Chapter 2 Install; Site Selection And Rack Mounting - Emerson Rosemount CT4400 Reference Manual

Reference Manual
00809-0100-4244
2 Install
2.1

Site selection and rack mounting

WARNING
HEAVY ITEM
Handle the analyzer with caution during unpacking, installing, maintaining, and
transporting to prevent crushing of hands, feet, or other body parts.
The analyzer weighs 33 lb (15 kg) for the half rack system and 66 lb (30 kg) for the full rack
system. Rosemount recommends that the analyzer is moved by a minimum of two people
when lifting and transporting the equipment.
Failure to properly handle the analyzer may cause injury to personnel, wear suitable
protective gloves and protective footwear.
Procedure
1. The analyzer MUST be installed in an enclosed environment that is protected from
2. Site selection for analyzer installation MUST account for the handles on the front
3. Screw in rubber feet have been fitted to the base of the analyzer – if required these
4. The full rack system has additional slotted holes on the front face for securing the
5. The minimum tubing and cabling allowance defined in
Reference Manual
the elements, humidity, and temperature variations for optimum performance.
face of the full rack system and rear entry for the cable and tube connections (see
Figure 2-1 and Figure 2-2).
can be removed to aid assembly into the rack system being provided.
analyzer to the rack system (see
the rear of the analyzer MUST be accounted for when installing the rack system.
Figure 2-1: Half Rack Installation Requirements
A. Four off M4 mounting holes for customer supplied mounting ears (if required)
B. Three off M4 mounting holes for customer supplied rail (if required)
Figure 2-2).
Figure 2-1
Install
January 2020
and Figure 2-2 at
23