Labview Rt Programming; Targeting Labview Rt To A Platform; Targeting Labview Rt To The Cfp-20Xx - National Instruments Compact FieldPoint cFP-20 Series User Manual

LabVIEW RT Programming

Targeting LabVIEW RT to a Platform

Targeting LabVIEW RT to the cFP-20xx

© National Instruments Corporation
This chapter contains specific information about targeting LabVIEW
Real-Time (RT) to the cFP-20xx module, network options for restricting
access to the module, embedding LabVIEW RT applications on the
module, and launching embedded applications when the module starts up.
For general LabVIEW RT programming information, refer to the LabVIEW
RT User Manual.
You can target LabVIEW RT to the cFP-20xx or to the host PC. When you
select a target platform other than the host PC, the RT Development System
downloads any LabVIEW RT application you subsequently run to the
selected target platform. Refer to Chapter 1, Introduction, and to Chapter 3,
Software Overview, of the LabVIEW RT User Manual for more
information about the RT Development System.
When you target LabVIEW RT to the cFP-20xx, you can run LabVIEW RT
applications on the controller. However, when targeted to the cFP-20xx,
LabVIEW RT lacks some features found in LabVIEW for Windows
because the controller does not have all the software of a PC. The following
LabVIEW functions are not supported in LabVIEW RT when targeted to
the cFP-20xx:
• ActiveX
• Front panel datalogging
• Dialog boxes
• Printing
• Programmatic menus
• Front panel Web publishing
• NI-DAQ
LabVIEW RT applications that have any of the unsupported functionality
previously listed may or may not work as expected on the cFP-20xx.
4-1
4
cFP-20xx and cFP-BP-x User Manual