I) Cutting Board Assembly; J) Installing Backsplash - Traulsen centerline CLUC-27R-SD Owner's Manual

III. i - CUTTING BOARD ASSEMBLY
On prep tables and mega top tables, the cutting board may
require assembly at the site.
Install cutting board brackets on each side with two screws.
With brackets installed, slide the cutting board in at an angle
under the lip in the back and then let it rest down with the
pins running through the holes on the board (see figure 4).
The cutting board is field reversible, reverse process to
reverse cutting board.
Fig. 4
III. INSTALLATION (continued)
-4-
III. j - INSTALLING BACKSPLASH
All 27", 36", 48", 60", & 72" wide compact undercounter
models can be supplied with an optional backsplash that
must be installed on-site. To do so, please follow the
directions below:
1. Install backsplash as shown in figure 5. The backsplash
is attached with self-drilling Philips head screws. The
outer most holes are used to install bumpers.
2. Align the outer holes used for the bumpers to attach the
backsplash. Attach the backsplash with the just the outer
holes and bumpers temporarily to hold in place.
3. Assure the front lip of the backsplash is contacting the
top of the unit. Use the self-threading sheet metal screws
to attach the inner portion through the hole locations on
the backsplash.
4. Use silicone or similar product to seal any gaps between
the backsplash and the exterior top.
Fig. 5