Page 1
MARINE BATTERY CHARGERS Voyager Series Installation/ Operation www.sentrychargers.com Linear Devices Corporation Phone: 804-368-8428 dba Sentry Fax: 804-368-8438 11126 Air Park Rd, Suite G Ashland, VA 23005...
Table of Contents Safety Precautions Serial Number Model Number Choosing Charging Curve Maintenance Precautions Technical Specifications Operation Instructions Assembling Shore Power Connector Dimensions 9-10 Warranty Disposal CE Conformity...
In order to avoid overcharging or irreversible damage to the materials, please follow closely all recommendations cited below. Do not install this system near inflammable materials. An owner should seek guidance from an authorized Sentry dealer or the factory. •...
(e.g.: 12 for 2012), a letter indicating the month of manufacture (e.g.: C for the month of March). Model Number SV = Sentry Voyager series 12 or 24 = DC Voltage Output 20, 40, 60… = DC Amp Output...
Choosing the charging curve. • It is extremely important to choose the correct charging curve, one which is appropriate for the battery type. An incorrect choice could cause irreversible damage. • This is particularly true for charging curves where the charging voltage is higher than the manufacturers’...
OPERATION INSTRUCTIONS MODE STATUS Steady The batteries are charging. Time required to complete Boost Yellow Boost mode varies depending on the initial status of the batteries, but is limited to 6 hours. Equalize Yellow The batteries are coming to the end of the Blinking charging cycle.
Assembling the shore power Connector 7Step 1: Remove approx .75” (2 cm) of the outer jacket. Remove approx. .3” (8 mm) of the inner wires insulation. Tin the stranded copper ends. 7Step 2: Remove the security cap using a screw driver. 7Step 3: Pull the conductor through the pre-latched strain relief housing.
WARRANTY In order to prevent all risks arising due to the incorrect use of this device, please carefully read the list of possible situations or faults that are not covered by the warranty. If the charger is dropped or experiences a hard impact, irreversible damage of the ventilation system and certain electrical components may result.
DISPOSAL This device contains electronic components & material that must be recycled once the device is obsolete. All obsolete electronic devices must be returned to a local distributor or to a specialized company for an environmentally friendly disposal. CE CONFORMITY This product conforms to current European standard and has a CE mark.