JVC LT-22HD7WU Instructions Manual page 14

Getting Started
First Time Installation - USB Connections
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
Press the side function switch until the TV comes on
from standby.
To Switch the TV Off
Press the " " button on the remote control or press
the side function switch until the TV switches into
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
First Time Installation
IMPORTANT: The TV may require you to set and
confirm a PIN number. Selected PIN number cannot
be 0000. Enter a PIN number and confirm it by
entering once more. Press OK button to continue. If
the two PIN numbers match, your master PIN number
will be set.
WARNING: When you are required to enter a PIN
number for any menu operation you should use the
PIN that you have previously defined during the first
time installation. If you have forgotten the PIN number
you have set during the first time installation, you
should use the master PIN code, 4725.
When turned on for the first time, the language
selection screen is displayed. Select the desired
language and press OK.
The First Time Installation (FTI) screen will be
displayed next. Set your preferences using the
navigation buttons and when finished, press OK to
continue.
If Home Mode is selected, Store mode will be
disabled after the First Time Installation. Press OK
button to continue and select Yes to proceed.
You can activate Store mode option to be available
in "Other settings" menu and your TV's features will
be illustrated on the top of the screen.
Default PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
Aerial Installation
If you select AERIAL option from the Search Type
screen, the television will search for digital terrestrial
TV broadcasts.
NOTE: You can press MENU button to cancel.
After all the available stations are stored, the Channel
List will be displayed on the screen. If you would like
the channels to be sorted according to the LCN (*),
please select "Yes" and then press OK.
Press MENU button to quit channel list and watch TV.
(*) LCN is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel sequence (if available).
Cable Installation
Select CABLE option and press OK button on the
remote control. To continue, you can select frequency
ranges from this screen.
Enter the frequency range manually by using the
numeric buttons and press OK to start the search.
Note: Searching duration will change depending on the
selected search step.
Media Playback via USB Input
You can connect a 2.5" and 3.5" inch (hdd with external power
supply) external hard disk drives or USB memory stick to your
TV by using the USB input of the TV.
IMPORTANT! Back up your files before making
any connections to the TV. Manufacturer will not be
responsible for any file damage or data loss. Certain
types of USB devices (e.g. MP3 Players) or USB hard
disk drives/memory sticks may not be compatible
with this TV. The TV supports FAT32 and NTFS disk
formatting but recording will not be available with
NTFS formatted disks.
While formatting a USB hard disk that has 1TB (Tera
Byte) or more file capacity, you can experience
problems with the formatting process. Do not
repeatedly quickly plug and unplug the drive. This
may cause physical damage to the USB player and
USB device itself. Do not pull out USB module while
playing a file.
English - 12 -