The infrared port does not work.
Check the following:
•
Make sure that the infrared ports of the two devices are facing
each other (+/- 15 degrees) a maximum of 1 meter apart.
•
Make sure there is a clear path between the two infrared ports.
Nothing should be blocking the ports.
•
Make sure you have the appropriate software running on both
devices (for file transfers) or you have the appropriate drivers (for
printing to an infrared printer).
•
During the POST, press F2 to access the BIOS Utility and verify that
the infrared port is enabled.
•
Make sure both devices are IrDA-compliant.
The printer does not work.
Check the following:
•
Make sure that the printer is connected to a power outlet and that
it is turned on.
•
Make sure that the printer cable is connected securely to the
computer's parallel port and the corresponding port on the
printer.
•
During POST, press F2 to access the BIOS Utility and verify that the
parallel port is enabled.
I want to set up my location to use the internal modem.
To properly use your communications software (e.g. HyperTerminal),
you need to set up your location:
1
Click on Start, Settings, Control Panel.
2
Double-click on Modems.
3
Click on Dialing Properties and begin setting up your location.
Refer to the Windows manual.
49